A-127 BOM Filter Breakout

105 

expansion module for A-127 offers notch filter for each sub-unit

Available on backorder

Add to Wishlist
Add to Wishlist
Estimated delivery 21 days

Description

In addition to A-127 is a breakout module A-127BOM. This expansion module offers the following additional functions:notch filter for each sub-unit
separate outputs for lowpass, highpass, bandpass and notch for each sub-unit
separate audio input with attenuator for each sub-unit
The breakout module allows the separate use of each of the three A-127 filters. In addition the filters can be patched parallel or serial. Especially the serial connection of three notches generates very complex phasing-like structures. For parallel filter connection the existing mixer of the main module may be used or an external mixer. For serial connection the filters are patched in the desired sequence at the breakout module. A jumper is used to define the filter type for each sub-unit for the mix unit of the main module.

Remark: The breakout module can be used without modification only in combination with the new version of the A-127 (pcb printing “Version 4”). Only the new version has the expansion connector available, that is required to connect the breakout module without soldering. It’s also possible to combine the breakout module with older versions of the A-127 (versions 1, 2 and 3) but in this case soldering is required to connect the breakout module to the main module (soldering 4 wires to each filter unit). The instructions how to connect A-127BOM and A-127 main module are available here: A127BOM.pdf. This document also describes how to wire older versions of A-127 to the A-127BOM.

Note: The front panel printing of the first production series is faulty. The highpass and bandpass are mixed up. If you cannot accept this drawback we ask you to wait for the second production series (about middle of 2015). The correct printing is BP right from LP and HP below LP.

Width: 8 HP / 141.9 mm
Depth: 55 mm (measured from the rear side of the front panel)
Current: +20mA (+12V), -20mA (-12V)

Specifications

brand

Doepfer

Reviews

There are no reviews yet.

Be the first to review “A-127 BOM Filter Breakout”

Your email address will not be published. Required fields are marked *

Search machineroom.com.ua

Login

Create an account

Your personal data will be used to support your experience throughout this website, to manage access to your account, and for other reasons described in our privacy policy.

Password Recovery

Lost your password? Please enter your username or email address. You will receive a link to create a new password via email.

SHOPPING BAG (0)

A-127 BOM Filter Breakout

105 

Available on backorder