A-176 Control Voltage Source


3 voltage sources, to use wherever an extra CV is required



Available on backorder

Add to Wishlist
Add to Wishlist
Estimated delivery 21 days
Category: Tags: , , ,


Module A-176 (Control Voltage Source) provides three voltage sources, to use wherever an extra CV is required. The top two voltage sources (CV 1 and CV 2) have controls for coarse and fine control of the voltage output; the third source (CV 3) just has the one control.
The range of the voltages output can be preset, either to 0 to +5 V or to -2.5 V to +2.5 V depending on your likely requirements. There is a jumper on the circuit board for each of the three voltage sources.
A typical use for the module would be to provide fine as well as coarse tuning for an A-110 standard VCO, (which, unlike the A-111, only has one tune control).
In general, this module will be useful whenever you need a manually controllable CV on a module which doesn’t itself have a built-in control.

For more detailed information please look at the English user’s guide: A176_man.pdf


Width: 8 HP / 40.3 mm

Depth:: 40mm (measured from the rear side of the front panel)
Current: +20mA (+12V) / -10mA (-12V)








There are no reviews yet.

Be the first to review “A-176 Control Voltage Source”

Your email address will not be published. Required fields are marked *

Search machineroom.com.ua


Create an account

Your personal data will be used to support your experience throughout this website, to manage access to your account, and for other reasons described in our privacy policy.

Password Recovery

Lost your password? Please enter your username or email address. You will receive a link to create a new password via email.


A-176 Control Voltage Source


Available on backorder